Ductless Mini-Split Maintenance (Condensing Unit) $169.00

  • Inspect, clean and service Mini Split Condenser (level condenser on the pad if necessary and possible), all high and low voltage wiring
  • Inspect contact, capacitor, compressor, condenser coil, fan blade, fan motor, the refrigerant charge (addition of refrigerant is additional)
  • Inspect line set, line set insulation (extra charge if this needs to be replaced)and disconnect box.  All indoor fan coil servicing and cleaning are $69.00 each.

Gas Furnace Maintenance $169.00

  • Inspect, clean and service natural gas/propane furnace, furnace blower assembly, squirrel fan, fan motor, capacitor
  • Check and adjust the tension on the belt
  • Lube motor
  • All high and low voltage wiring
  • Inspect contact, burner relay, vent pipe, supply and return plenums.
  • Brush and clean furnace flue and vent pipe to chimney.
  • Replace furnace filter (customer to provide or replacement is extra).
  • Inspect thermostat (battery replacement is extra) and combustion test

Oil Boiler Maintenance $229.00

  • Inspect, clean and service oil boiler, burner box.
  • Replace nozzle, oil filter, all high and low voltage wiring.
  • Inspect contact, burner relay, burner motor, coupler, fuel pump pressure, relays, zone valve, circulators, expansion tank, auto feed, pressure relief valve, air vent, aqua-stat, check valve, ball valves, gate valves, vent pipe, supply and return piping, low motor cutoff.
  • Brush and clean boiler flue and vent pipe to chimney, thermostat and combustion test.

Oil Furnace Maintenance $189.00

  • Inspect, clean and service oil furnace blower assembly, squirrel fan, fan motor, and capacitor.
  • Check and adjust the tension on belt and oil motor.
  • Replace nozzle, and oil filter (spin on filter cartridge extra), all high and low voltage wiring.
  • Inspect contact, burner relay, burner motor, coupler, fuel pump pressure, electrodes, vent pipe, supply and return plenums.
  • Brush and clean furnace flue and vent pipe to chimney.
  • Replace furnace filter (customer to provide or replacement is extra).
  • Thermostat and combustion test.

Gas Boiler Maintenance $179.00

  • Inspect, clean and service natural gas or propane boiler, burner box, all high and low voltage wiring.
  • Inspect contact, relays, zone valve, circulators (lube if needed), expansion tank, auto feed, pressure relief valve, air vent, aqua-stat, check valve, ball valve, gate valves, vent pipe, supply and return piping, low water cutoff, condensate trap, condensate line, condensate pump, thermostat (battery replacement is extra) and combustion test.

Gas/Propane Water Heater Maintenance $109.00

  • Inspect water heater for leakage, condition, gas valve, CO test
  • Drain water from the bottom of a water heater until it is clear
  • Replace thermocouple and check for gas leaks

Oil Water Heater Maintenance $129.00

  • Inspect, clean and service water heater
  • Drain water from the bottom of the water heater until it is clear
  • Check for tank leakage, replace the nozzle, replace oil filter (spin on filter cartridge extra), all high and low voltage wiring
  • Inspect contact, burner relay, burner motor, coupler, fuel pump pressure, relays, ball valves, gate valves, vent pipe, supply and return piping
  • Brush and clean boiler flue and vent pipe to chimney and combustion test

Dryer Vent Maintenance $99.00

  • Inspect, service and clean dryer vent.
  • Inspect for broken or split vent and vented to outside.
  • Remove outdoor vent cover and brush lint out.
  • Remove dryer vent from the dryer and brush lint out.
  • Vacuum out vent connection on the dryer.
  • Tape dryer vent if possible and repair. Replacement is an additional charge.

Oil Boiler Maintenance $229.00

  • Inspect, clean and service oil boiler, burner box.
  • Replace nozzle, oil filter, all high and low voltage wiring.
  • Inspect contact, burner relay, burner motor, coupler, fuel pump pressure, relays, zone valve, circulators, expansion tank, auto feed, pressure relief valve, air vent, aqua-stat, check valve, ball valves, gate valves, vent pipe, supply and return piping, low motor cutoff.
  • Brush and clean boiler flue and vent pipe to chimney, thermostat and combustion test.